Supply water fire monitor, foam fire monitor

Specifications

1.Maximum working pressure: 1.0Mpa
2.Normal working pressure: 0.8Mpa
3.Flow rate:24,32,64L/S
4.Regular fire monitor
 

1.regular fire monitor

2.Discharge distance ≥60M

3.Level round angel: 360°

4.Pitch angel: -15°~ +70°

5.Discharge angel: 100°

6.Connect: DN100

Over the past few years, we has pushed and expanded its product line to Fire monitors, Foam monitors, Remote controlled minotors,fire valves, foam bladder tanks etc. Unlike most fire equipment manufacturers, we also delivers on the meaning of custom-crafted appatatus. Working side-by-side with each customer, Shengxin will construct your vehicle based on your specific department's needs, our team — from the best engineers and draftsmen to highly skilled mechanics and craftsmen will always give you a surprise on the quality. Any monitor is as unique as our customers, as part of our family and legacy.

A. Introductions

PSD Adjustable Fire Monitor has characteristic with adjustable flow rate, distant range and wide discharging range.and the discharge range is also adjustable-----have both straight stream and fog stream. It can be installed in the places of flammable or explosive chemical circumstance, airport, oil area, oil transport wharf, shipyard etc. It is an efficient equipment for putting out fire, and it is also can be fixed on fire vehicles.

B.Schematic drawing

1. hand wheel (horizontal movement ) : casting iron with chrome plated

2. hand wheel(Vertical movement): Casting iron with chrome plated

3. pressure gauge: stainless steel

4. limit switch: stainless steel

5. flow control switch: stainless steel

6. Fog/Straight stream switch: aluminum alloy

(the main body is aluminum alloy, the nozzle is aluminum alloy and brass, you see the yellow color on the photo is brass )

C.Specifications

D.Manipulation

1.Check the bolts and nuts on the inlet flange, to make sure there are tightly fixed on each other.

2.Adjust the pipe water pressure to the rated pressure range of the monitor, read the pressure gauge while adjusting.

3.When you want straight stream nozzle, rotate the [ 6 (Fog/Straight stream switch) ] handle in the clockwise direction; and if you want fog nozzle, roate counter-clockwise.

4.when you want adjust the flow rate, push the “4.limit switch” from right side to left side, and then rotate “5. flow control switch” to the flow rate you want.

5.hand wheel 1 and 2 is used to adjust the horizontal and vertical directions of the nozzle.

E.Maintenance

1.Cleanse the monitor inside and outside after every usage.

2.If the monitor is used in frozen areas, drain the water in the nozzle after usage in case of frozen, which will damage the monitor.

3.Lubricate the worms, worm wheels, bearings, ect. Termly.

4. Replace the rubber seal rings termly in case of aging which will result in leaking water.

F.Packing list and easy-damaged part(s):