Precaution, Pretection and Safety, all in FireTC
Inquiry For Fire Testing
Recommended Service
Hot Fire test center
Your location: Home » Fire test center » Standards & Regulation » USA » Text

ASTM D4963玻璃绳和玻璃布的点燃损失标准试验方法

Zoom  Zoom Issue Date:2012-02-07   Browse:1204
ASTM D4963玻璃绳和玻璃布的点燃损失标准试验方法
ASTM D4963  Standard Test Method for Ignition Loss of Glass Strands and Fabrics
ASTM D4963玻璃绳和玻璃布的点燃损失标准试验方法

This test method is considered satisfactory for acceptance testing of commercial shipments because current estimates of between-laboratory precision are acceptable.
In cases of a dispute arising from differences in reported test results when using this test method for acceptance testing of commercial shipments, the purchaser and the supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens which are as homogeneous as possible and which are from a lot of material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using Student's t-test for unpaired data and an acceptable probability level chosen by the two parties before the testing begins. If a bias is found, either its cause must be found and corrected or the purchaser and the supplier must agree to interpret future test results in the view of the known bias.
Glass fiber textiles are provided with various sizings or coatings. These provide a protection for the individual fibers, yarns, or fabric that may compose the glass fiber textile as well as compatibility with further finishing requirements. The amount of sizing or coating on glass fiber textiles as determined by this procedure is used for process control.
1. Scope
1.1 This test method covers primarily the determination of ignition loss of glass fiber textiles. This method applies to glass fiber strands, twisted or untwisted, coated or uncoated; and fabrics, woven, nonwoven, knitted, coated, and uncoated, and chopped strand. This procedure may be applied to other glass textiles where the amount of organic content obtained by ignition loss is required.
Note 1—This test method may be used with other glass fiber classifications, such as C or D, but a different ignition temperature and exposure time may be required. In these cases the manufacturer should be consulted for the appropriate ignition conditions.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)
ASTM Standards
D123 Terminology Relating to Textiles
D578 Specification for Glass Fiber Strands
D7018 Terminology Relating to Glass Fiber and Its Products
Index Terms
glass fabrics; glass textiles; glass yarns; ignition loss; Acceptance criteria/testing--textile fabrics/fibers; Glass fabrics/fibers/textile products; Ignition--textile materials/products; Loss on ignition (LOI) ;
[ Fire test center Search ]  [ ]  [ Forword to friends ]  [ Print ]  [ Close ]  [ Back to Top ]


Home | About us | Contact | Terms & Conditions | Copyright | Site Map | Friend link | Guestbook | Old Version | 闽ICP备09009213号
©2013-2015 FIRETC.NET All Rights Reserved   ICP:闽ICP备09009213号-4